Compaq ALPHASERVER DS10 - Page 56

DS10 Console Reference
1-42
help
The help (or ?) command displays the LFU command list, shown below.

*YRGXMSR(IWGVMTXMSR

(MWTPE](MWTPE]WXLIW]WXIQkWGSRJMKYVEXMSRXEFPI
)\MX(SRII\MX0*9VIWIX
0MWX0MWXWXLIHIZMGIVIZMWMSRJMVQ[EVIREQIERHYTHEXI
VIZMWMSR
0JY6IWXEVXW0*9
6IEHQI0MWXWMQTSVXERXVIPIEWIMRJSVQEXMSR
9THEXI6ITPEGIWGYVVIRXJMVQ[EVI[MXLPSEHEFPIHEXEMQEKI
:IVMJ]'SQTEVIWPSEHEFPIERHLEVH[EVIMQEKIW
#SV,IPT7GVSPPWXLMWJYRGXMSRXEFPI

lfu
The lfu command restarts the LFU program. This command is used when the
update files are on a floppy disk. The files for updating both console firmware
and I/O firmware are too large to fit on a 1.44 MB disk, so only one type of
firmware can be updated at a time. Restarting LFU enables you to specify
another update file.
list
The list command displays the inventory of update firmware on the CD-ROM,
network, or floppy. Only the devices listed at your terminal are supported for
firmware updates.
The list command shows three pieces of information for each device:
•
Current Revision — The revision of the device’s current firmware
•
Filename — The name of the file used to update that firmware
•
Update Revision — The revision of the firmware update image
readme
The readme command lists release notes for the LFU program.