DeviceMaster Installation and Configuration Guide: 2000594 Rev. F Managing the DeviceMaster - 127
Managing the DeviceMaster
3. If necessary, enter the password and press Enter. If a password has not been set, press Enter. If using an
SSH session, press Enter to the login as prompt.
Note: If the PuTTY screen flashes in the background and does not appear as shown above, make sure
that Enable Telnet/ssh has not been disabled in SocketServer. To check this, return to PortVision
DX, right-click the DeviceMaster in the Device List pane, and click Webpage. Click the Security
tab and if necessary, verify that the Enable Telnet/ssh option is enabled, If it is not, click the
option and then click Save, and close SocketServer.
4. Type Reset, press Enter, and close the telnet session.
To Next Page
Loading...
