34 - Initial Configuration DeviceMaster Installation and Configuration Guide: 2000594 Rev. F
PortVision DX Requirements
PortVision DX Requirements
Use PortVision DX to identify, configure, update, and manage the DeviceMaster on Windows Server 2008 R2
through Windows 10 operating systems.
PortVision DX requires that you connect the Comtrol Ethernet attached product to the same network segment
as the Windows host system if you want to be able to scan and locate it automatically during the configuration
process.
Note: You must install PortVision DX v3.02 or higher to load firmware with a .cmtl extension.
Configuring Security Settings and PortVision DX
The following list provides basic PortVision DX operations that are affected how the DeviceMaster interacts
with PortVision DX when security is enabled using the web interface (SocketServer/NS-Link).
• PortVision DX must scan the DeviceMaster before configuring security.
• PortVision DX locates the DeviceMaster before setting either Secure Data Mode or Secure Config Mode.
• If PortVision DX discovers the DeviceMaster after setting security, the following conditions occur:
- A lock symbol displays before the Device Name.
- The IP address of the DeviceMaster does not display.
-The Software Settings and Web Interface tabs are not present in the Properties page.
- The IP mode displays as DHCP without the ability to modify.
-The Upload and Reboot icons on the Launch Bar are grayed out and the options are disabled in the
popup menus.
Note: If the DeviceMaster was previously configured with security, PortVision DX features are reduced.
To Next Page
Loading...
