DeviceMaster Installation and Configuration Guide: 2000594 Rev. F Socket Port Configuration - 61
Socket Port Configuration
This section provides an overview of SocketServer and provides basic operating procedures. SocketServer and
DeviceMaster security are discussed in detail in
DeviceMaster Security on Page 65.
Note: Technical Supports recommends that you update to the latest version of SocketServer before installing
an NS-Link device driver or configuring socket ports.
SocketServer Overview
SocketServer is the name of the TCP/IP socket web page that is integrated in the firmware that comes pre-
installed on your DeviceMaster. When you install an
NS-Link device driver, an NS-Link version of
SocketServer loads on the DeviceMaster.
The SocketServer home page (Server Info) provides basic information about the DeviceMaster including
whether it is functioning in socket mode (SocketServer) or in NS-Link (driver). See SocketServer Architecture
on Page 62 for more information about socket port support.
The following menus are available in the web interface:
• Port, which includes the following pages:
- Port Overview of all of the serial port settings
- Port Configuration for each port that includes Serial, TCP connection, and UDP connection
configuration capabilities
• Network, which includes the following pages:
- Configuration for general, IPv4 and IPv6 settings (after initial configuration)
- Password to set a device password
- Security, which is discussed in detail starting on Page 65
- Keys/Certs to manage security keys and certificates
- Email for notification services
- RFC1006 (ISO over TCP)
• Diagnostics, which includes:
-System Log
-Port Monitor
• System, which includes:
- Update Firmware
- Configuration File
- Device Snapshot
- Restore Defaults
-Reboot
Note: For socket service configuration procedures or information, see the web page Help system.
To Next Page
Loading...
