Comtrol DeviceMaster PRO - Page 138

138 - RedBoot Procedures DeviceMaster Installation and Configuration Guide: 2000594 Rev. F
RedBoot Procedures
sernum [prefix] [serial_number]
sernum [serial_number]†
Displays device serial number (if available).
? Displays short help.
snmp [disable|enable] Sets or displays SNMP enable.
summary
Displays a summary that includes the bootloader version, network
address information, MAC address, and security settings.
telnet [disable | enable} Sets or displays telnet server enable. Disables telnet.
teltimeout [seconds] Shows or sets telnet time-out.
terse Terse command response mode.
t485 port #1 port #2
Runs port-to-port RS-485 test. This is not available on the DeviceMaster
Serial Hub. Port numbering is Port 0 through 15 and you must connect a
straight-through cable such as Ethernet patch cord.
timeout {seconds} Displays or sets Bootloader time-out value.
version Displays RedBoot version information.
† Read-only items that you cannot change in Redboot.
RedBoot Commands (Continued)