Configuration and Setup 3-25
4. Closed Loop Cal should be displayed as the first option. If not use the arrow down
button to reach it. Press to confirm.
5. Your display should now look like this (the actual text on the 2. line will show the current
setting for the option and may be different than the one shown below).
6. Press to move the “>” mark to the current setting so you can change it. Use the
arrow buttons up/down
until you reach the media type (Coated, Semi Glossy,
Glossy…) that describes the media in your printer. Press to confirm.
7. On “Print Sheet” select Enter. The system will print a color patch sheet.
8. Feed the sheet into the scanner
9. The display will now show “Scan Sheet”. Select to start. The system will scan the
color patch sheet and calculate color matching values for future jobs with the current media
type.
10. When you use the system for copying, you will select the option for the Media Type that
matches the media loaded on your printer. This is done through the Menu button. The
system will then load the corresponding Media Profile and use it to create optimal color
output for the job.
Read more on Media Type selection under the section How do I make a Copy –
Other Copy Options - How do I Set the Media Type.
> Closed Loop Cal
To Next Page
Loading...
