Scanner Operation - Panel and Indicators 4-16
scanner’s central power switch has been turned OFF manually and its clock needs to be
reset.
3. If the scanner is in use then the scanner will delay Sleep mode. Just before automatic Sleep
mode with the timer occurs, the power LED on the panel will flash. You can cancel Sleep
mode by pressing the power button.
4. Note that the Idle time before sleep time setting will still apply and may conflict with your
Timer settings. Change the Idle time before sleep time setting if it does.
4.9 Idle Time before sleep time
On Scanners:
These scanners support an Idle time before sleep time functionality in addition to the Timer
function described in the previous section. The Idle time before sleep time functionality is an
ENERGY STAR
®
compliant feature.
NOTE: On delivery, your scanner was set to comply with the ENERGY STAR
®
environmental
guidelines with entry into power down mode after being idle for 15 minutes. When you start the
scanner the first time, you are offered the option to change this. If you chose to keep the default
settings at that opportunity, you can at any later time change the settings by following the
instructions below:
To change the Idle time before sleep time (minutes) value…:
1. Double-click on the scanner icon in the system tray to display the WIDEsystem interface.
2. Select the Timer Tab.
3. Select or Deselect the Enter Sleep mode automatically option in the Timer tab dialog.
4. If you selected the option, use the arrows to select the Idle time before sleep time value –
the number of minutes the scanner can stand idle before powering down on its own.
5. Press Apply to download your settings into the scanner’s memory.
To Next Page
Loading...
