Configuration and Setup 3-26
3.10 Scanner on Network Setup
In order to be recognized on the network, your copy scanner needs to identify itself. Some
networks support DHCP which will enable the scanner to extract its network setup information
automatically from the network. On other networks, you will have to enter the network ID
information manually.
On scanners:
To apply the scanners network setup settings:
On the iJET Panel
1. Select the Menu button.
2. Use the arrow button up or down until the display window shows Advanced and
confirm with the Enter button .
3. Use the arrow buttons up or down until the display shows Network Setup and confirm
with .
4. The rest depends on if your network supports DHCP or not. Follow one of the scenarios
below:
If your network supports DHCP:
1. Use the arrow button up or down until the display window shows DHCP Setup and
confirm with to move the “>” marker down change the setting.
2. Use arrows down/up to select YES and confirm with
Enter
. The scanner will then
get its network setup information directly from the networks DHCP server.
Change value to “YES” and confirm with
Enter
DHCP Setup
> YES
Press
Enter
to confirm DHCP
setup
> DHCP Setup
NO
Ente
To Next Page
Loading...
