Using the scanner, how do I …? 6-11
6.2.8 Using Scan Software – From Local PC or Network PC
The “Scan/Copy station on Local PC” configuration was described in the section on “Setup and
Configuration”. Scanning to file with this configuration can take place through scan software
installed on the PC. The software would control the scanner and all settings and operation
would take place from the PC.
If the scanner is connected and setup with network identification on the LAN and is enabled for
sharing, PCs on the LAN can recognize and use the scanner if compatible scan or copy
software is installed on the PC. The PCs must also have WIDEsystemNET installed.
For both of these cases, please refer to the scan/copy software documentation and on-line help
for the most up-to-date instructions on using the specific software application with the scanner.
Be sure to view the on-line help for WIDEsystemNET for information on scanner sharing and
scanning to a designated folder (to a network PC) on the LAN.
Please refer to this Operator’s Guide section on Scanner On Network Setup and Setup to
Share the Scanner for details on enabling your scanner to be recognized on the LAN and
shared by network PCs.
To Next Page
Loading...
