Contex GX67D - Printer Setup on the Scanner

Configuration and Setup 3-21
3.8 Printer Setup on the Scanner
In order to be operated from the iJET Panel, your copy scanner needs to recognize a printer.
The setup procedure depends on whether you connect a printer through the USB host (output)
port or through a LAN port (either directly or indirectly). Direct connection through the LAN port
will require that you enter the local printer’s IP address. If you connect to the network through
the LAN port and want to use a printer on that network, you will have to enter the network
printer’s IP address.
On scanners:
To apply printer setup settings:
On the iJET Panel
1. Select the Menu button.
2. Use the arrow button up or down until the display window shows Advanced and
confirm with the Enter button .
3. Use the arrow buttons up or down until the display shows Printer Setup and confirm
with .
4. You can set up a Color Printer and a B&W Printer (max 2 printers at a time). Press
to reach the Color Printer option.
5. Press to confirm Color Printer and reach the Interface option and again to
confirm Interface. Use arrows down/up to select USB or LAN, depending how you
connected your color printer and confirm your selection with .
Interface
> USB
Use arrows to change the Interface setting. Press
Enter
to confirm.
> Color Printer
…
Press
Enter
to confirm
Printer setup
> Printer Setup
…
Ente
r
Load Delay
> 3
Use arrows to change the
Load Delay value and confirm with
Enter
.
> Load Delay
0
Use arrow down to reach the
Load Dela
y
option. Press
Enter
Ente
r
Ente
r
Ente
r
Ente
r
Menu
Ente
r