Using the scanner, how do I …? 5-5
5.2.2 How do I… Set a Scale factor? – Output size
In the beginning of this section (How to… make a copy) we described how to set the input size
with the Size button. You can enlarge or reduce this size in your output copy through the Scale
option. The Scale value is defined as a percent (factor) of the original. A scaling factor of 100%
means that the copy inherits the original’s size, under 100% means it is reduced and over 100%
means it is enlarged. The scaling factor can be selected from a list of predefined factors and if
needed, these can be fine tuned to create your own factors.
To set a Scale factor:
On the iJET Panel –
1. Quick - Press the Scale button. The iJET Panel display will open the Scale
option with the “>” marker on the value level indicating you can immediately change the
Scale option’s value. From here you can skip steps 2 and 3 and go to step 4 to change the
value.
2. Menu – Press the button to enter the main Menu.
Use the arrow up/down buttons
to move through the Menu options until the display
shows Scale %.
3. Press
Enter
to move the “>” marker down to indicate you want to change the Scale factor
value.
4. There are two ways to change the value:
5. Repeated presses to the Scale button will change the Scale factor value forward though
a list of predefined Scale factor values. The value list wraps around meaning that you step
from 800 to 25 when you continue to press the button.
6. Or…press the arrow up/down buttons
to change the Scale factor value in single
value steps. You can use this to fine tune one of the predefined values you reached by
pressing the Scale button as described above.
7. Select a value larger than 100 to enlarge the image and smaller than 100 % to reduce the
image.
8. Press the
Enter
button to accept the selected value. The “>” marker will move up to the
Menu level indicating that the value is set and you can step on through the menu options if
> 200
To Next Page
Loading...
