iJET Panel Quick Reference Guide 10-25
Options ->
Load Delay
(not available on
flatbed scanners)
This option is active
if Media Handling
(above) s set to
Auto
Load.
Set a delay factor for
Auto Load. 0-1000
Default: 0
•
Set a delay factor value - the scanner will
use the value to determine how long it waits
before it pulls the original into the scanner.
The option is used to give you time to
position and align the paper for a straight
path.
Service ->
Service ->
Replace Lamp
(available on flatbed
scanners only)
To move the lamp to a position
at the slide-door opening at the
back of a flatbed scanner so the
lamp can be pulled out and
removed.
‘Enter’ to go
Press
Enter to position the lamp.
You can open the scan area cover to see the
lamp moving into position.
Wait until you hear the motor stop before
attempting to remove the lamp.
Service ->
Reset Lamp Cnt.
For all scanners. For resetting
the flag that tells users when it is
time to replace the lamp.
‘Enter’ to go
Press Enter if you have just replaced the lamp
with a new one. The internal flag will be reset to
zero and from there keep track of scanner lamp
usage.
Service ->
Print Settings
Print out all your system’s iJET
panel settings in order to review
them.
‘Enter’ to go
Press Enter to start the printout.
To Next Page
Loading...
