CPI COTI - Section 2 - Installation; Siting Your Machine

Secon 2 - Installaon
Technical Manual
Secon 2 - Installaon
Important! It is essenal that the personnel responsible for installing and servicing
your machine understand the following:
The installaon and commissioning of your machine should only be carried out by a trained
and authorised service technician.
All water and electrical services must be correctly and safely connected in compliance with
naonal and local regulaons.
All covers must be replaced correctly and securely and your machine le in a safe
condion.
2.1 Sing your Machine
Your machine is only suitable for indoor use. It should be kept out of direct sunlight and
away from any heat source. This machine is not suitable for installaon in an area where a
water jet or hose and nozzle may be used.
Your machine should be located near the appropriate water and electrical services.
Prior to placing your machine in its nal locaon, ensure that there is sucient access
space available via hallways, stairs, elevators etc.
Ensure that access to the machine is restricted to personnel who have knowledge and
praccal experience of the appliance, in parcular as far as safety and hygiene are
concerned.
To ensure adequate venlaon, 4 - 6 inches (100 –150mm) clearance must be allowed
between the back of the cabinet and the wall.
The Vender must be posioned close enough to an electrical outlet so that an extension
cord is not required.
The Vender must be on a solid, at and level surface.
Do not transport the Vender to, from or around customer locaons when there ia water in
the tank loaded with product. Be sure to test Vender for proper operaon before pung
in to service on locaon.
Level your machine in both the front-to-back and side-to-side planes by adjusng the feet.
Ensure that the door opens and closes easily and the lock operates correctly.
The Vender should never be slid or pushed in place. Never side load the leveling legs; doing
so will cause damage to the legs.
COTI
Ensure the ooring can bear the weight load of a fully loaded Vender
(approximately 405 lbs. or 184 kg).
Ensure the ooring can bear the weight load of a fully loaded Vender
If the Machine will be subject to user misuse or vandalism, it is recommended that
the Vender be secured to the oor or wall.
Due to the large size and weight of the Vender, never aempt to move the Vender with a
Hand Truck or Stair Climber. Use a pallet jack or Vender/Cooler Dollies at all mes when
moving the Vender.
7