CPI COTI - Security Codes

Secon 5 - Engineer’s Program
Technical Manual
 Idle Time Seconds - This is the period of inacvity necessary prior to the reboot.
Enter the required period using the displayed numeric keypad and press Save.
5.11.23 Buzzer Sengs
This enables the sounds when touching the selecon interface buons to be varied.
1. Buzzer Enabled - This Enables or Disables the buzzer.
2. Buzzer Selecon - Select between Low Beep, Medium Beep or High Beep. This is the
length of the tone, reducing it makes it less intrusive in the local environment.
5.11.24 Debug Log Enable
This feature is Enabled or Disabled. When enabled this feature allows a log to be taken of
the events within the machine which can then be sent to technicalsupport@cranems.eu for
analysis.
The log is taken by inserng a USB sck (on which you have created a folder named “logs”
in the root menu) into the USB 3 socket on the atlas board. When the log has been
downloaded onto the sck the screen will instruct you to remove the USB sck.
Note: THIS FEATURE MUST BE ENABLED TO ALLOW AN MDB LOG TO BE TAKEN. (see
secon 5.4.3)
5.11.25 Display OOS Errors
When enabled this feature will display errors on the User Interface seen by the customer.
5.11.26 LED Device Type
This enables the selecon of the LED colour scheme.
1. Select the required colour type from those available on the LED Device Type screen to
display the colours available in that type.
2. Selecng Red LED will display a red colour scheme on the Display Screen.
3. Selecng RGB Led type allows various colour schemes to be acvated. (if the necessary
hardware is ed)
5.12 Security Codes
The security code for entry into the Engineer’s Program is factory set so that the engineer
presses the sequence of four numbers on the drink selecon interface.
This screen enables these entry and keyless vend codes to be changed.
Note: On no account should the rst three codes be altered without rst consulng your
supervisor or manager.
1. Enter Pin - by entering the Operator PIN you will be taken into the Operator menu
2. Change Engineer PIN - this displays and enables the pin to be changed for entry into
the Engineer’s program.
3. Change Operator PIN - this displays and enables the pin to be changed for entry into
the Operator’s program.
99