CPI COTI - Page 108

Secon 5 - Engineer’s Program
5.11.17 Soware Version
This displays the current soware: Release, I/O Board Version, Kernel, Build Number and
Touchscreen version numbers.
5.11.18 Temperature Units
The enables the temperature to be displayed in either Celsius or Fahrenheit.
5.11 19 Keyless Transions
This enables the user to vend into a jug or vend free of charge on entry of the correct
passcode.
1. This can be Enabled or Disabled
2. Transion Time - a value is entered aer which the machine reverts to it’s normal vend
mode. This me is aer inacvity or the cup is removed.
3. If this feature is enabled the consumer must select the MY CODE icon to display the
MY CODE keypad. There are two codes:
 Jug Vend - 9999 followed by the site specic four digit code set in the Security
Code menu (secon 5.12)
 Free Vend - 9998 followed by the site specic four digit code set in the Security
Codes menu (secon 5.12)
Note: It is highly recommended that the four digit site specic codes are changed from
their default values
5.11.20 Standby Screen
This enables a series of standby screens or videos to be displayed aer the machine has
remained idle for a set me. This funcon can be Enabled or Disabled and the Transion
Time entered aer which the Standby Screens are displayed.
It also enables the selecon of the types Credit Cards and Bills/Notes that can be used in
the machine. These are also displayed on the User interface for the consumer to see, refer
to Secon 4.12.6 for more informaon.
5.11.21 Default Dispense Head Posion
This is the posion of the dispense head aer a vend, the two opons available are:
 Home - fully retracted into the machine.
 Fully Extended - remains extended in the vend posion.
5.11.22 Automac Reboot Sengs
The machine is set up to reboot automacally at 2am, this will only occur if the machine has
remained idle for 300 seconds (5 minutes). These sengs can be changed to run at a more
convenient me e.g. to suit work shi paerns.
 Automac Reboot -This can be disabled but this is not recommended.
 Reboot Time - This enables the me at which the reboot will occur to be changed, use
the displayed screen to set the hours and minutes. Once entered Save the new me.
98