CPI COTI - Page 6

Introducon / Important Informaon
Important! This appliance is not intended for use by persons (including children under
8 years old and the inrm) with reduced physical, sensory or mental capabilies or lack
of experience and knowledge. Unless they have been given supervision or instrucon
concerning use of the appliance by a person responsible for their safety and they fully
understand the hazards involved.
Children should be supervised to ensure that they do not play with the appliance.
Children must not carry out any cleaning of maintenance of the machine.
These machines are designed to be used in an Indoor Seng only. Indoor Seng is dened
as inside a structure constructed with four walls and a roof, suciently protected from
ambient condions and not subjected to the eects of weathering. Any other usage is in
direct violaon of these instrucons and will void the warranty of the machine and its
components. Because it is a beverage machine it should be sited in a clean and hygienic area.
ACCEPTABLE AMBIENT OPERATING TEMPERATURE RANGE
This equipment was designed and tested to work properly in a temperature range of 50°F to
90°F (10°C to 32°C) in sll air (40% Relave Humidity, non-condensing). Usage at ambient
condions outside the range of the tesng may cause unacceptable appearance or
performance.
STORAGE CONDITIONS
The machine is capable of being stored in a temperature range of 32°F - 155°F (0°C - 68°C ).
Water should always be drained prior to storage especially if at lower temperatures.
Machines must not be double stacked when in storage.
RECEIVING INSPECTION
DO NOT STORE THE VENDER OUTSIDE.
Upon receipt, inspect the Vender for any shipping damage. If there is any damage, have the
delivery driver note the damage on the bill of lading and nofy Crane Merchandising Systems
Customer Service. Although the terms of sale are FOB shipping point, which requires the
consignee to originate shipping damage claims, Crane Merchandising Systems will gladly help
if you must le a claim.
UNPACKING THE VENDER
Remove the stretch wrap, berboard edge protectors and corrugated front protector from
the outside of Vender.
Do not store the Vender with stretch wrap on. Stretch wrap could
bond to the Vender’s surface, which could damage the nish.
COTI - Remove the shipping boards from the boom of the Vender. To avoid unnecessary
damage to the leveling feet or base, remove the shipping boards by using a 1-1/2 inch or 38
mm spanner to unscrew the leveling feet. Be sure to replace the legs aer removing the
shippingboards.
LINEA - remove the transit plates from the packaging pallet.