Spider DSA User’s Manual
148
Record Option
Figure 105. Record Time Stream Setup
For the Record Time Stream function shown above, the options are provided to
determine when and how the software should record the time stream data. Unlike
the Save Signal function, Recording function requires two actions (start recording
and stop recording) when conditions are met.
Conditions of start recording are illustrated below.
• Manually start recording by pushing buttons
This is the option by default and the most commonly used. User needs to press
the Record button on the control panel to start recording, and press the same
button again to stop recording when the stop recording event is not checked.
Either the event action or the Recording button can stop the recording.
• When measurement starts
The recording starts as soon as the measurement starts in this case. User can set
a stop recording event, set a run duration, or press the Stop Recording button to
stop the recording.
To Next Page
Loading...