Spider DSA User’s Manual
46
Clicking this button will bring up the un-deformed display mode setup window as
following,
Figure 265. Un-deformed Display Mode
Point, Line, Surface, Label, and Model can be selected so that the un-deformed
elements will be shown with the animation of the model.
Animation Equation Editor
Clicking this button will bring up the Animation Equation Editor window.
Figure 266. Animation Equations Editor
The un-measured DOFs will be listed in the editor window. Click the plus icon on
the right hand, will allow the editing of the Animation equation for that DOF.
Typically, the measured DOF can be called and summed with a coefficient.
Animation with Interpolation
This is the toggle button. When it is toggled on, the animation will be done with
the interpolated DOFs deforming per equation defined in the previous step.
Increase amplitude
Action button to increase the animation amplitude.
To Next Page
Loading...