Disable: Egress rewriting is disabled.
Enable: Enable egress rewriting is enabled but with remapping.
Remap DP aware: Frame with DSCP from analyzer is remapped and remarked with the remapped DSCP value.
Depending on the frame’s DP level, the remapped DSCP value is either taken from the DSCP Translation table, Egress
Remap DP0 or DP1 field.
Remap DP unaware: Frame with DSCP from analyzer is remapped and remarked with the remapped DSCP value. The
remapped DSCP value is always taken from the DSCP Translation table, Egress Remap DP0 field.
4.19.7 DSCP-Based QoS
DSCP: DSCP value in ingress packet. DSCP range is from 0 to 63.
Trust: Select the checkbox to indicate that DSCP value is trusted. Only trusted DSCP values are mapped to a specific QoS
class and drop precedence level (DPL). Frames with untrusted DSCP values are treated as non-IP frames.
QoS Class: Select the QoS class to the corresponding DSCP value for ingress processing. By default, 0 is used. Allowed
range is 0 to 7.
DPL: Select the drop precedence level to the corresponding DSCP value for ingress processing. By default, 0 is used. The
value “1” has the higher drop priority.