4.2.5 System Auto Provision Configuration
Configure auto provision on this page.
Auto Provision Mode: Indicates the auto provision operation mode. Possible modes are:
Enabled: Enable auto provision mode operation. When auto provision mode operation is enabled, the device can
download software and configuration automatically.
Disabled: Disable auto provision mode operation.
HTTP/FTP Login: Indicates the HTTP/FTP downloading mode operation. Possible modes are:
Enabled: When HTTP/FTP Login is enabled, the device downloads software and configuration with username and
password if given at below.
Disabled: Downloads software and configuration without username and password.
HTTP/FTP Username: If both Auto Provision Mode and HTTP/FTP Login are enabled, this username is used as the ID when
logging into HTTP or FTP server. The allowed string length is 0 to 20,
HTTP/FTP Password: If both Auto Provision Mode and HTTP/FTP Login are enabled, this password is used as the secret
when logging into HTTP or FTP server. The allowed string length is 0 to 20.
4.2.6 System NTP Configuration
Configure NTP (Network Time Protocol) on this page.
Mode: Indicates the NTP mode operation. Possible modes are:
Enabled: Enable NTP client mode operation.
Disabled: Disable NTP client mode operation.
Server #: Provides the IPv4 or IPv6 address of a NTP server. IPv6 address is in 128-bit records represented as eight fields
of up to four hexadecimal digits with a colon separating each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol
'::' is a special syntax that can be used as a shorthand way of representing multiple 16-bit groups of contiguous zeros; but
it can appear only once. It can also represent a legally valid IPv4 address. For example, '::192.1.2.34'.
To Next Page
Loading...
