4.21 UPnP
Mode: Enable or disable UPnP operation.
TTL: TTL (Time to live) is used to configure how many steps an UPnP advertisement can travel before it disappears.
Advertising Duration: This defines how often an UPnP advertisement is sent. The duration is carried in Simple Service
Discover Protocol (SSDP) packets which informs a control point how often it should receive a SSDP advertisement
message from the switch. By default, the advertising duration is set to 100 seconds. However, due to the unreliable
nature of UDP, it is recommended to set to the shorter duration since the shorter the duration, the fresher is UPnP status.
4.22 Diagnostics
The “Diagnostics” menu provides ping function to test the connectivity of a certain IP and VeriPHY cable diagnostics.
4.22.1 Ping
This Ping function is for ICMPv4 packets.
IP Address: Enter the IP address that you wish to ping.
Ping Length: The size or length of echo packets.
Ping Count: The number of echo packets will be sent.
Ping Interval: The time interval between each ping request.
To Next Page
Loading...
Need help?
General
