V1 Leaves Received: The number of Received V1 Leaves.
Router Port
Port: The port number.
Status: Indicate whether a specific port is a router port or not.
4.11.2.5 Groups Information
VLAN ID: Display the VLAN ID of the group.
Groups: Display the group address.
Port Members: Ports that belong to this group.
4.11.2.6 IPv6 SFM Information
VLAN ID: Display the VLAN ID of the group.
Group: Display the IP address of a multicast group.
Port: The switch port number.
Mode: The filtering mode maintained per VLAN ID, port number and group address.
Source Address: The source IP address available for filtering.
Type: Display either Allow or Deny type.
Hardware Filter/Switch: Indicates whether the data plane destined to the specific group address from the source IPv4
address can be handled by the chip or not.
4.12 LLDP
LLDP (Link Layer Discovery Protocol) runs over data link layer which is used for network devices to send information
about themselves to other directly connected devices on the network. By using LLDP, two devices running different
network layer protocols can learn information about each other. A set of attributes referred to TLVs are used to discover
To Next Page
Loading...
Need help?
General
