Once is clicked in display page, the following page will appear.
QCE Configuration
Port Members: Select ports that use this rule.
Key Parameters
Tag: Select VLAN tag type (Tag or Untag). By default, any type is used.
VID: Select VID preference. By default, any VID is used. Select “Specific”, if you would like to designate a VID to this QCL
entry. Or Select “Range”, if you would like to map a range of VIDs to this QCL entry.
PCP: Select a PCP value (either specific value or a range of values are provided). By default, any is used.
DEI: Select a DEI value. By default, any is used.
SMAC: Select source MAC address type. By default, any is used. Select “Specific” to specify a source MAC (first three
bytes of the MAC address or OUI).
DMAC Type: Select destination MAC address type. By default, any is used. Other options available are “UC” for unicast,
“MC” for multicast, and “BC” for broadcast.
Frame Type: The frame types can be selected are listed below.
Any: By default, any is used which means that all types of frames are allowed.
Ethernet: This option can only be used to filter Ethernet II formatted packets. (Options: Any, Specific – 600-ffff
hex; Default: ffff). Note that 800 (IPv4) and 86DD (IPv6) are excluded. A detailed listing of Ethernet protocol
types can be found in RFC 1060. A few of the more common types include 0800 (IP), 0806 (ARP), 8137 (IPX).
LLC: LLC refers to Link Logical Control and further provides three options.
SSAP: SSAP stands for Source Service Access Point address. By default, any is used. Select specific to
indicate a value (0x00 - 0xFF).
DSAP: DSAP stands for Destination Service Access Point address. By default, any is used. Select specific
to indicate a value (0x00 to 0xFF).
To Next Page
Loading...
Need help?
General
