SNMP Trap Configuration
Configure SNMP trap on this page.
Trap Mode: Indicates the SNMP trap mode operation. Possible modes are:
Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.
Trap Version: Indicates the SNMP trap supported version. Possible versions are:
SNMP v1: Set SNMP trap supported version 1.
SNMP v2c: Set SNMP trap supported version 2c.
SNMP v3: Set SNMP trap supported version 3.
Trap Community: Indicates the community access string when sending SNMP trap packet. The allowed string length is 0
to 255, and the allowed content is ASCII characters from 0x21 to 0x7E.
Trap Destination Address: Indicates the SNMP trap destination address. It allows a valid IP address in dotted decimal
notation ('x.y.z.w'). Also allowed is a valid hostname. A valid hostname is a string drawn from the alphabet (A-Za-z), digits
(0-9), dot (.) and dash (-). Spaces are not allowed. The first character must be an alpha character, and the first and last
characters cannot be a dot or a dash.
Trap Destination IPv6 Address: Indicates the SNMP trap destination IPv6 address. IPv6 address is in 128-bit records
represented as eight fields of up to four hexadecimal digits with a colon separating each field (:). For example,
'fe80::215:c5ff:fe03:4dc7'. The symbol '::' is a special syntax that can be used as a shorthand way of representing multiple
16-bit groups of contiguous zeros; but it can appear only once. It can also represent a legally valid IPv4 address. For
example, '::192.1.2.34'.
Trap Authentication Failure: Issues a notification message to the specified IP trap managers or not whenever SNMP
authentication request fails.
Enabled: Enable trap authentication failure.
Disabled: Disable trap authentication failure.
Trap Link-up and Link-down: Issues a notification message whenever a port is link up and link down.
Enabled: Enable trap link-up and link-down.
Disabled: Disable trap link-up and link-down.
Trap Dying gasp: Enable or disable dying gasp trap sent to the server.
Enabled: Enable dying gasp trap mode operation.
To Next Page
Loading...
Need help?
General
