2.3 Emergency procedures
I
n
t
roduction
This section describes how to shut down NanoAssemblr Ignite or Ignite+ instrument in
an emergency situation, and the result in the event of power failure.
The section also describes the procedure for restarting the instrument.
Emergency shutdown
In an emergency situation, follow the steps below to stop the run:
Step Action
1 Tap S
TOP on the user interface, or open the lid.
R
esult:
All run activities are stopped.
2 Press the power switch to the O
po
sition to completely turn off power to the
instrument.
3 Unplug the power cord from the wall socket.
2 Safety instructions
2.3
Emergency procedures
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 14
To Next Page
Loading...
