cytiva NanoAssemblr Ignite - Optional: Preheat the System

6.3.3 Optional: Preheat the system
In
troduction
The Ignite and Ignite+ systems offer optional heating, for procedures that use pre-
heated liquids. The heating block preheats the syringes and holds the temperature of
the syringes in the C and R channels above ambient temperature for the duration of
the run.
IMPORTANT
While C and R syringes are heated independently, they are only
able to maintain a maximum offset of 30°C. For example, if the R
syringe temperature is set to 75°C and the C syringe temperature
is set to 25°C, the actual C syringe temperature will reach 45°C.
The table below gives the limitations on temperature for each of the instruments.
Instrument Temperature
Ignite
Up to 75°C
Ignite+
Up to 65°C
Preheat the instrument
Be
fore you begin, make sure that the heating insert or inserts are correctly sized for the
syringes used in the run. See Section 3.5.1 Heating insert, on page 38 for compatibility.
Note:
Only C and R channels can be used with heating.
Step Action
1 Open the lid of the instrument.
2 Rotate the rotating block upwards so that the underside of the cartridge is
vi
sible.
6 Operation
6.
3 Run a procedure
6.3.3 Optional: Preheat the system
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 83