6.3.1 Workflow
Th
e table below explains the main phases of a run.
Phase Description
0 Optional: Pre-heat the system and reagents
1
I
nitiate the run using an existing recipe, or by starting a quick run
No
te:
When Quick run is chosen, all parameters must be entered manually.
2
Load the cartridge
3
Load the syringes, collection tubes, and waste tubes
N
ote:
The steps in this phase depend on whether the heaters are used.
4
Start the formulation
5
After formulation is complete, remove the sample and waste tubes
6
Disconnect and dispose of used cartridge and syringes
6 Operation
6.
3 Run a procedure
6.3.1 Workflow
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 80
To Next Page
Loading...
