4.2 Installing the system
I
n
troduction
This section describes the procedure for installing the Ignite or Ignite+ system.
Safety precautions
WARNING
Power cord. Only use power cords with plugs delivered or
approved by Cytiva.
WARNING
Pr
otective ground. The product must be connected to a
grounded power outlet.
WARNING
Ac
cess to power plug. Do not block access to the power outlet
and power plug. The power cord with plug must always be easy to
disconnect.
Place the instrument on the bench
Pl
ace the instrument on the bench (see Space requirements, on page 45 for space
requirements). Lift the instrument from the base. It is recommended to use two people
to lift the instrument.
4 Installation
4
.
2 Installing the system
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 49
To Next Page
Loading...
