cytiva NanoAssemblr Ignite - Prerequisites and Required Materials

6.3.2 Prerequisites and required materials
Pr
erequisites
The Ignite or Ignite+ must be installed by trained personnel. If syringe heating is used,
the heating block must be installed by authorized Cytiva personnel.
The correct size of sample arm must be installed prior to running a procedure. See
Section 5.4 Replace sample arm, on page 73 for information about replacing the
sample arm.
Required materials supplied by
Cytiva
Prior to starting a procedure, make sure you have the following available:
Material Description
Single use cartridge Ignite instrument: One of the following cartridges:
• Cl
assic
• NxGen
• NxGen Dilution
Ignite+ instrument: One of the following cartridges:
• Cl
assic
• NxGen
• NxGen Dilution
• NxGen 500
• NxGen 500D
Heating inserts (optional) If the procedure uses syringe heating: up to two
he
ating inserts; one heating insert for each channel
that uses heating. See Section 3.5.1 Heating insert,
on page 38 for information about heating insert
compatibility.
Required materials supplied by the
us
er
Prior to starting a procedure, make sure you have the following available:
6 Operation
6
.
3 Run a procedure
6.3.2 Prerequisites and required materials
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 81