The Ignite or Ignite+ can be installed on a standard laboratory bench.
Pr
epare a clean working area on a stable laboratory bench that complies with the spec-
ifications in the following table. There must be sufficient space to turn the instrument
on the bench for service access to the rear panel.
Parameter Specification
Minimum bench area for operating the
in
strument (W x D x H)
40 x 44 x 73 cm (15.7 x 17.3 x 28.7 in)
Load capacity Enough to support instrument and any
ot
her accessories on the laboratory
bench
Inclination of bench surface Horizontal ±2°
4 Installation
4.
1 Site preparation
4.1.2 Room requirements
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 46
To Next Page
Loading...
