Step Action
1 Connect the power supply to the port at the rear of the NanoAssemblr Ignite
or Ignite+ instrument.
Note:
To
remove the power supply from the instrument, slide the sheath of the
connector backwards while pulling the connector out.
2 Connect the power supply to the power cord.
3 Connect the power cord to a grounded wall outlet with a voltage according
to the site requirements in Electrical power requirements, on page 48.
4 Installation
4.
4 Electrical connections
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 54
To Next Page
Loading...
