DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
166
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry, enter the correct information and then click Create. To return to the Access Profile List window, click
<<Back.
The following parameters can be configured.
Parameter Description
Ethernet ACL
To configure this profile select the Ethernet ACL, and use the drop-down menu to choose
between Tagged or Untagged.
Source MAC Mask
Enter a MAC address mask for the source MAC address.
Destination MAC
Mask
Enter a MAC address mask for the destination MAC address.
Select ACL Type
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 or packet content
mask. This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 to instruct the Switch to examine the IPv4 address in each frame's
header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame’s
header.
Select Packet Content Mask to specify a mask to check the content of the packet
header.
802.1Q VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for VLAN Mask (0-FFF).
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
Ethernet Type
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
Click Create to view the new Access Profile List entry in the Access Profile List table shown below. To add another
Access Profile click Add ACL Profile. To delete a profile click the corresponding Delete button, to view the specific
configurations for an entry click the Show Details button. To add a rule to the Access Profile entry, click the Add/View
Rules button.
Figure 7- 5 Access Profile List window
To view the configurations for previously configured entries, click on the corresponding Show Details button, which
will display the following window:
To Next Page
Loading...
