DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
181
Figure 7- 29 CPU Access Profile List window
This window displays the CPU Access Profile List entries created on the Switch. To view the configurations for an
entry, click the corresponding Show Details button.
To add an entry to the CPU Access Profile List, click the Add CPU ACL Profile button. This will open the Add CPU
ACL Profile window, as shown below. To remove all CPU Access Profile List entries, click the Delete All button.
The Switch supports four CPU Access Profile types: Ethernet (or MAC address-based) profile configuration, IP (IPv4)
address-based profile configuration, IPv6 address-based profile configuration, and Packet Content Mask.
The window shown below is the Add CPU ACL Profile window for Ethernet:
Figure 7- 30 Add CPU ACL Profile window (Ethernet)
Parameter Description
Profile ID This value can be set from 1 to 5.
Select ACL Type
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet content
mask. This will change the window according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IPv4 to instruct the Switch to examine the IPv4 address in each frame's header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content Mask to specify a mask to check the content of the packet header.
Source MAC
Mask
Enter a MAC address mask for the source MAC address.
To Next Page
Loading...
