DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
182
Destination MAC
Mask
Enter a MAC address mask for the destination MAC address.
802.1Q VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each packet header
and use this as the full or partial criterion for forwarding.
802.1P
Selecting this option instructs the Switch to specify that the access profile will apply only to
packets with this 802.1p priority value.
Ethernet Type
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
Click Create to set this entry in the Switch’s memory.
To view the settings of a previously correctly created profile, click the corresponding Show Details button on the CPU
Access Profile List window. The following window opens:
Figure 7- 31 CPU Access Profile Detail Information window (Ethernet)
The window shown below is the Add CPU ACL Profile window for IPv4.
Figure 7- 32 Add CPU ACL Profile window (IPv4)
The following parameters may be configured for the IP (IPv4) filter.
Parameter Description
Profile ID This value can be set from 1 to 5.
Select ACL Type
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet
content mask. This will change the window according to the requirements for the type of
To Next Page
Loading...
