D-Link DGS-3700-12 - 802.1 X

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
194
srTCM – Single Rate Three Color Marker, marks packets green, yellow or red based on a rate
and two burst sizes. This is useful when only burst size matters.
• CIR (Kbps) – Specifies the Committed Information Rate of the packet. The range is 0 to
1000000.
• CBS (Kbyte) – Specifies the Committed Burst Size of the packet. The unit is Kbyte. That
is to say, 1 means 1Kbyte. The maximum value is 16*1024. The range is 0 to 16384.
• EBS (Kbyte) – Specifies the Excess Burst Size of the packet. The unit is Kbyte. That is
to say, 1 means 1Kbyte. The maximum value is 16*1024. The range is 0 to 16384.
Action
Conform – Specifies the action when the packet is in “green color” mode.
• Replace DSCP – Allows you to change the dscp of the packet
• Counter – Allows you to set the counter of the packet.
Exceed – Specifies the action when the packet is in “yellow color” mode.
• Permit – Permits the packet.
• Replace DSCP – Allows you to change the DSCP of the packet.
• Counter – Allows you to set the counter of the packet.
• Drop – Drops the packet.
Violate – Specifies the action when the packet is in “red color” mode.
• Permit – Permits the packet.
• Replace DSCP – Allows you to change the DSCP of the packet.
• Counter – Allows you to set the counter of the packet.
• Drop – Drops the packet.
Click Apply to implement changes made, click <<Back to return to the ACL Flow Meter window.