D-Link DWC-2000

D-Link DWC-2000 User Manual 142
Section 5 - Advanced Network Conguration
Routing
A static route tells network devices about an exact, xed (hard-coded) destination. Static routes can work well
with small networks. There are two kinds of static routing: Static Route and Protocol-Binding. The Static Route
uses IP address to determined where is the next hop, whereas Protocol-Binding use protocol. Conguring your
wireless controller for static routing allows data transfers between it and a routing device without needing to
use dynamic routing protocols.
Congure IPv4 Static Routing
Path: Network > Routing > IPv4 Static Routes
To add a static route:
1. Click Network > Routing > IPv4 Static Routes.
2. Click Add New Static Route. The Static Route Conguration page will appear.
3. Complete the elds in the table on the next page and click Save.