D-Link DWC-2000

D-Link DWC-2000 User Manual 118
Section 5 - Advanced Network Conguration
IPv6 LAN Settings
Path: Network > IPv6> LAN Setting> IPv6 LAN Settings
In IPv6 mode, the LAN DHCP server is disabled by default (similar to IPv4 mode). The DHCPv6 server will serve
IPv6 addresses from congured address pools with the IPv6 Prex Length assigned to the LAN.
The default IPv6 LAN address for the controller is fec0::1. You can change this 128 bit IPv6 address based on your
network requirements. The other eld that denes the LAN settings for the controller is the prex length. The
IPv6 network (subnet) is identied by the initial bits of the address called the prex. By default this is 64 bits long.
All hosts in the network have common initial bits for their IPv6 address; the number of common initial bits in the
network’s addresses is set by the prex length eld.
1. Go to Network > IPv6 > LAN Settings > IPv6 LAN Settings tab.
2. Complete the elds in the table below and on the next page.
3. Click Save.
Field Description
LAN TCP/IP Setup
IPv6 Address
The Wireless Controller’s LAN IPv6 address.
IPv6 Prex Length
The IPv6 network (subnet) is identied by the initial bits of the address called
the prex. All hosts in the network have the identical initial bits for their IPv6
address; the number of common initial bits in the networks addresses is set by
the prex length eld.