D-Link DWC-2000

D-Link DWC-2000 User Manual 160
Section 5 - Advanced Network Conguration
Setup CoS and DSCP Marking
Path: Network > QoS > CoS DSCP Marking
Remarking CoS to DSCP is an advanced QoS conguration, where the Layer 2 quality of service eld is translated
to a Layer 3 QoS eld in the packet, so that upstream routers can make a QoS decision based on the DSCP
eld set in the packet. Once you enable CoS to DSCP marking by choosing the check box, you can choose the
appropriate value of the DSCP for a given CoS value.
1. Go to Network > QoS > CoS DSCP Marking.
2. Enable CoS and DSCP Marking and click Save.
3. Right-click on the CoS and select Edit. Change the mapping value between CoS and DSCP.
4. Click Save.