D-Link DWC-2000

D-Link DWC-2000 User Manual 36
Section 3 - Basic Conguration
Step #6: Conrm Access Point Prole is Associated
Use the following procedure to conrm that the access point prole is associated with the wireless controller.
Note: Each time you change conguration settings, perform this procedure to apply the changes to the access point.
1. Go to Wireless > Access Point > AP Prole.
2. Under Access Point Prole List, right-click on the AP prole you want to update and click Apply.
3. Wait 30 seconds and then click the refresh icon to verify that the prole is associated. Your associated
access point is congured and ready to authenticate wireless users.