D-Link DWC-2000

D-Link DWC-2000 User Manual 20
Section 3 - Basic Conguration
Log in to the Web Management Interface
Conguration procedures using the wireless controller’s web management interface are performed using one of
the following supported web browsers:
• Microsoft Internet Explorer 9.0 or higher
• Mozilla Firefox 23 or higher
• Apple Safari 5.1.7 or higher (Windows)
• Apple Safari 6.1.3 or higher (iOS)
• Google Chrome 26 or higher
Before you perform the following procedure:
• Congure your PC running the web browser to use an IP address on the 192.168.10.x network, with a
subnet mask of 255.255.255.0.
• Congure your web browser to accept cookies, prompt for pop-ups, and allow sites to run JavaScript.
• Upgrade the rmware for your wireless controller (see “Upgrading Firmware” on page 20).
• Upgrade the rmware for your access points after you upgrade the wireless controller rmware (refer to
the documentation for your access points).
To log in to the web management interface:
1. Launch a web browser on the PC.
2. In the address eld of your web browser, type the IP address for the wireless controller web
management interface. The default IP address is http://192.168.10.1. A login prompt will appear. If
the login prompt does not appear, see “Web Management Interface” on page 257.
3. If you are logging in for the rst time, the default user name is admin and the default password is
admin. Both the user name and password are case-sensitive.
Note: We recommend that you change the password to a new, more secure password (see “Editing Users” on
page 174) and record it in Appendix A.