D-Link DWC-2000

D-Link DWC-2000 User Manual 245
Section 8 - Maintenance
Congure SNMP Access Control List
1. Go to Maintenance > Management > SNMP > Access Control List tab.
2. Click Add Access Control.
3. Complete the information on elds (refer to the table below).
4. Click Save.
Field Description
IP Address The IP Address of the SNMP trap agent.
Subnet Mask The network mask used to determine the list of allowed SNMP managers.
Community The community string to which the agent belongs.
Access Type Access will be either read only (ROcommunity) or read-write (RWcommunity).