D-Link DWC-2000

D-Link DWC-2000 User Manual 29
Section 3 - Basic Conguration
Step #4: Change the SSID and Set Up Security
You can congure up to 50 separate networks on the wireless controller and apply them across multiple radio
and virtual access point interfaces. By default, 16 networks are pre-congured and applied in order to the access
points on each radio. In this procedure, you will edit one of the pre-congured networks and change its SSID and
security settings to suit your requirements.
1. Click Wireless > Access Point > AP Prole > AP Prole SSID. The following page will appear with a list
of the wireless networks congured on the wireless controller.
2. Under the SSID Status column, select an SSID by right-clicking on it and clicking Edit. The following page
will appear.