DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
160
DWS-3160-24PC:admin#disable captive_portal
Command: disable captive_portal
Success.
15-3 config captive_portal
Description
This command is used to configure the Captive Portal’s global settings on the Switch.
Format
config captive_portal [http_port [<int 0-65535> | default] | https_port [<int 0-65535> | default]
| statistics_interval [0 | <int 15-3600> | default] | authentication_timeout [<int 60-600> |
default]]
Parameters
http_port - Specifies to configure an additional HTTP port.
<int 0-65535> - Enter the additional HTTP port value used here. This value must be between
0 and 65535. Ports 80 and 443 cannot be used as they are reserved. The default value is
0. The value 0 specifies that no additional HTTP port will be used.
default - Specifies that the default value will be used.
https_port - Specifies to configure an additional HTTPS port.
<int 0-65535> - Enter the additional HTTPS port value used here. This value must be
between 0 and 65535. Ports 80 and 443 cannot be used as they are reserved. The default
value is 0. The value 0 specifies that no additional HTTPS port will be used.
default - Specifies that the default value will be used.
statistics_interval - Specifies the time interval, at which statistics are reported in the Cluster
Controller, used.
0 - Specifies that statistics interval option will be disabled.
<int 15-3600> - Enter the statistics interval value used here. This value must be between 15
and 3600 seconds. The default value is 120 seconds.
default - Specifies that the default value will be used.
- Specifies the time interval for authentication timeout.
<int 60-600> - Enter the authentication timeout value used here. This value must be between
60 and 600 seconds. The default value is 300 seconds.
default - Specifies that the default value will be used.
Restrictions
Only Administrators can issue this command.
Example
To configure the Captive Portal’s additional HTTP port:
To Next Page
Loading...
