5
-
17
1. This tractor is not equipped with a
separate parking brake. However
uses the brake pedals instead.
2. Make sure to interlock the left and
right brake pedals before applying
the parking brake.
3. Pull the parking brake lever up with
the brake pedals depressed fully to
engage the pedals with the latch.
If the braking force is insufcient,
depress the pedals more rmly.
4. Before leaving the tractor after
parking it, make sure to stop the
PTO, lower the implement onto the
ground, and stop the engine.
5. If it is necessary to leave the trac-
tor with the engine running, put all
the shift levers in the neutral posi-
tion and apply the parking brake
rmly.
6. When parking the tractor on a
slope, stop the engine with the
parking brake applied and engage
the low speed gear. Also, put the
shuttle shift lever into the forward
driving position on an uphill and
into the reverse driving position on
a downhill.
7. If it is necessary to park the tractor
on a slope with the engine running,
chock all four wheels and perform
Steps 4 and 5 above.
8. In order to release the parking
brake, depress the brake pedals
rmly again.
If the parking brake is applied
without the brake pedals inter-
locked, the braking force is ap-
plied to the wheel on one side
only, resulting in poor braking
performance and an accident.
The brake disc can be rapidly
worn if you drive with the park-
ing brake applied.
Never park the tractor on a
steep slope in any circum-
stance. A severe accident can
happen.
WARNING
TE150 (EX50, EX55)-���-05.indd 17 2019-03-19 �� 7:03:17