5
-
18
EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
The tractor may move slowly
with the engine running even
though the main and shuttle
shift levers are in the neutral
position. This is normal and is
due to the uid friction in the
transmission. This symptom
can occur easily when the
engine rpm is high, the low
speed gear is selected by the
range shift lever, and the vis-
cosity of the transmission uid
is high due to low tempera-
ture. To prevent this symptom,
make sure to apply the parking
brake.
Get off the tractor after check-
ing that the tractor is com-
pletely stopped and the park-
ing brake is rmly applied.
Do not park the tractor on tall
grass or hay. If grass or hay
contacts with the muffler, it
can catch re.
IMPORTANT
You should turn slowly by lowering
the engine rotation if possible.
TURNING
To prevent accidents due to loss
of steering control:
If you turn at high speed, the
tractor can turn over.
Never use the differential lock
system turning at high and low
speeds. A serious accident can
occur.
WARNING
DRIVING ON SLOPE
1. Please drive according to the con-
ditions of the slope at safe speed
so that the engine is not under
heavy load if possible.
2. Make sure to shift to the lower
gear in order to prevent the engine
from stalling on an uphill.
3. On the downhill slope, drive at the
low speed.
"Unlike a gas pedal, these HST
pedals act like a main speed
shift in a mechanical tractor".
Therefore, depress them deep-
er to obtain higher speed with
lower torque and release them
to obtain lower speed with
higher torque.
For heavy load job, such as
front end loader operation, use
low or medium speed of the
range shift lever.
IMPORTANT
TE150 (EX50, EX55)-���-05.indd 18 2019-03-19 �� 7:03:17
To Next Page
Loading...
