Daedong EX50-SA - Adjustment of Top Link; Precaution for Installing How to Use Top Link Holes

6
-
6
EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
PRECAUTION FOR INSTALLING
HOW TO USE TOP LINK HOLES
When attaching an implement, con-
nect it according to its draft as follow:
• A : Traction power is not required
(Rotary etc.)
• B : Heavy load traction work
• C : Normal load traction work
1. Adjust an angle of the implements
to the desired position by shorten-
ing or lengthening the top link.
2. Adjusting a proper length of imple-
ments varies as a type of imple-
ments used.
(1) Top Link

Stop the engine and lower
the attachment on the ground
prior to disconnecting the lift
rod from the lower link. Check
that the attachment for proper
supporting and there’s pres-
sure remained in the hydraulic
system to remove the lift rod
holding the pin. To eliminate
the remained pressure, move
the hydraulic adjusting lever
back and forth several times.
WARNING

When there is no implement at-
tached, fix the lower link to the
check link (LH/RH) so that it does
not contact with the rear wheel.
Secure the top link to the hook.
NOTE
(1) Top Link (2) Pin
(3) Retainer Pin (4) Top Link Hook
1. Install the top link to the desired
position, and install the pin and re-
tainer pin.
2. Fix Top link with xed nut after ad-
justing top link.
ADJUSTMENT OF TOP LINK
T46O602A
H11O536A
TE150 (EX50, EX55)-���-06.indd 6 2019-03-19 �� 2:31:32