Daedong EX50-SA - 3-POINT HITCH CONTROL SYSTEM

5
5
-
23
OPERATION
•
When driving on a road with an
implement attached to the rear
of the tractor, the friction of the
front wheels becomes poor,
resulting in poor steer ability. In
this case, attach a proper front
weight and drive at a low speed.
•
If malfunction occurs while driv-
ing on a road, stop the tractor
in a safe place and service it. If
it is not possible to move the
tractor, set a warning triangle
behind the tractor. Otherwise,
an tail gate accident may occur.
•
The center of gravity of the trac-
tor is higher compared to other
common vehicles, so the pos-
sibility of the roll-over accident
is very high. Be extra careful
when driving on a lateral slope,
bumpy road, road with puddles,
and narrow road. Make sure to
set the ROPS in its original po-
sition and fasten the seat belt.
WARNING
•
If stopping the engine while
driving, the steering perfor-
mance can become deterio-
rated due to loss of hydraulic
power, resulting in a severe
accident. Never stop the en-
gine while driving.
•
Do not release the steering
wheel to return to the straight-
ahead position after turning
while driving. The steering
wheel in this tractor is not a
self-return type. Releasing the
steering wheel while driving
may lead to a massive acci-
dent.
WARNING
3-POINT HITCH CONTROL
SYSTEM
(1) Position Control Lever
(A) Lowering (B)Lifting
The 3-point hitch can be controlled
by the position control lever and the
draft control lever. The lever installed
on the outer side (away from the
driver) is the position control lever
while the lever installed on the inner
side (close to the driver) is the draft
control lever.
T46O701A
TE150 (EX50, EX55)-���-05.indd 23 2019-03-19 �� 7:03:18