Daedong EX50-SA - Checking Transmission Fluid Level(D)

EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
7
-
10
CHECKING TRANSMISSION FLUID LEVEL(D)
1. Park the machine on a at surface,
lower the implement and shut off
engine.
2. Depress the brake pedals and ap-
ply the parking brake.
3. Set all shift levers into the neutral
position.
4. Stop the engine.
•
Be careful not to spill during
refueling. If a spill occur, wipe
it off at once, or it may cause
a re.
•
If unit is not used for a long
time, make sure the fuel vis-
cosity is suitable for the cold
weather.
IMPORTANT
(1) Gauge (2) Oil Filler Plug
(A) Oil Level is Acceptable Within This Range.
T46OA05A
(1) Oil Dipstick
(A) Upper Limit (B) Lower Limit
5. Pull out the oil dipstick, clean it,
and then insert it into its original
position. Then, pull it out again and
check if the oil level is within the
specied range.
6. If the oil level is too low, add some
new oil so that the level is within
the allowable range. (Refer to
"Lubricant" in this chapter for uid
specs)
TE5O703A
TE150 (EX50, EX55)-���-07.indd 10 2019-03-19 �� 4:36:23