Daedong EX50-SA - Checking Engine Oil Level(E)

7
MAINTENANCE
7
-
11
CHECKING ENGINE OIL LEVEL(E)
1. Check the engine oil daily.
2. Park the tractor on a level ground
and lower the implement.
3. If the engine was just running,
wait for approx. 5 minutes before
checking the oil level.
To avoid personal injury :
•
Be sure to stop the engine be-
fore checking the oil level.
CAUTION
•
If oil level is low, do not run
engine.
•
Never add the oil over the up-
per limit.
•
Be sure to check the oil level
after installing hydraulic
implement. Add the fluid as
needed.
•
Check the oil level with the
cylinders of an implement ex-
tended and check again with
cylinders retracted. Add the oil
to adjust average oil level in
the range of the oil limit. (Upper
or lower)
IMPORTANT
(1) Oil Inlet (2) Dipstick
(A) Oil Level is Acceptable Within This Range.
T46OA04A
4. Pull out the oil dipstick, clean it,
and then insert it into its original
position. Then, pull it out again and
check if the oil level is within the
specied range.
5. If the oil level is too low, add some
new oil so that the level is within
the allowable range.
(1) Oil Dipstick
(A) Upper Limit (B) Lower Limit
TE5O704A
TE150 (EX50, EX55)-���-07.indd 11 2019-03-19 �� 4:36:23