Daedong EX50-SA - Replacing Transmission Fluid and Filter(M)

EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
7
-
16
REPLACING TRANSMISSION FLUID AND FILTER(M)
The transmission fluid should be
changed if it is contaminated or after
the transmission is serviced or every
800 hours of operation. When chang-
ing the transmission uid, make sure
to change the fluid filter. However,
replace the filter only at initial 50
hours and every 400 hours operation
afterward.
1. Park the tractor on a level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
3. To drain the used fluid, place the
oil container under the transmis-
sion case and remove the drain
plug to drain used uid. If the uid
does not ow out freely, unscrew
(1) Oil Filter Cartridge
(1) Drain Plug
T46OA14A
T46OA18A
1. Park the tractor on a level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
3. To drain the used fluid, place the
oil container under the transmis-
sion case and remove the drain
plug to drain used uid. If the uid
does not flow out freely, unscrew
the breather plug on the top of the
hydraulic cylinder on the behind
of the top link bracket to facilitate
drainage. (Ref to next page)
Reinstall the drain plugs securely
afterward.
4. Unscrew the fluid filter from the
rear right section on the tractor us-
ing a lter wrench.
TE150 (EX50, EX55)-���-07.indd 16 2019-03-19 �� 4:36:25